Print-ready business card, free
A PDF your printer will accept: 85.6 by 54 mm with 3 mm of bleed, crop marks on the cut line, and a QR code sized to actually scan. No account, no email, no watermark.
Layout
Design
Thirty to start from. Everything below can still be changed.
Essential
Bold
Dark
Natural
Luxe
Editorial
Technical
Soft
Make it yours
Text colour is chosen for you so it can always be read.
- Card size
- 85.6 by 54 mm, the standard
- With bleed
- 91.6 by 60 mm, 3 mm each side
- Safe margin
- Nothing within 4 mm of the cut
What makes a file print-ready
Three things, and a printer will reject or silently botch a file missing any of them.
Bleed
3 mm of extra artwork past the cut, on all four sides. Cards are cut in stacks and the blade drifts. Bleed is what stops a white sliver appearing along an edge.
Safe margin
Nothing important within 4 mm of the cut line. Same reason: the cut moves, and text near the edge is the first casualty.
A code that scans
Around 2 cm square, with a clear quiet zone around it. A code shrunk to fit a corner is the most common reason a printed card does not work.
One thing this file cannot do
The code it writes is static. The address lives inside the pattern, so it can never be pointed somewhere else. If you change the link, move the booking page, or leave the company, every card already printed is wrong and the only fix is printing again.
That is fine for an address that will not move. Where it might, the answer is a code that redirects through a link you control, so the printed card stays correct while the destination changes behind it. That is what VCardForever does, and it is the whole reason the product exists.
Questions
What size is a business card for printing?
The finished card is 85.6 by 54 mm, which is the ISO/IEC 7810 ID-1 size used almost everywhere. Your artwork file should be larger than that, because of bleed.
How much bleed does a business card need?
3 mm on every side, so the page you supply is 91.6 by 60 mm. Bleed is artwork that runs past the cut line and gets trimmed away. Without it, a cut landing half a millimetre off leaves a white sliver along the edge, which is the single most common reason a card comes back wrong.
What is the safe zone on a business card?
Keep text and anything you cannot afford to lose at least 4 mm inside the cut line. Cutting is accurate to about half a millimetre, and stacked cards are cut together, so the ones at the bottom of the stack drift furthest.
How big does a QR code need to be on a business card?
About 2 cm square is the practical minimum for a phone held at normal reading distance. Smaller can work, but it depends on the printer, the paper and the light, and you only find out after the cards arrive. The file this page makes sizes the code for you.
What is the quiet zone around a QR code?
A clear margin around the code, with nothing printed in it, so a camera can tell where the code ends. The standard asks for four modules, which is roughly the width of four of the small squares in the pattern. Crowding a code with text next to it is a common reason it scans slowly or not at all.
Will the printer accept this file?
It is a PDF at the right page size, with bleed and crop marks, in vector rather than pixels, so it stays sharp at any size. That is what a print shop asks for. If yours wants CMYK or a specific colour profile, tell them this is RGB and they will convert it.
Can I change where the code points after printing?
Not with this file. The code here is static: the address is encoded in the pattern itself, so changing it means new cards. That is fine for a link that will never move, like your own domain. If it might move, a code that redirects through a short link you control is the thing to use instead.